|
Ultra-DrainGuards |
| Properties | ASTM Test |
Value |
||||
| Grab Tensile Warp | D4632 | 215 | ||||
| Strength (lbs) Fill | ||||||
| Elongation | D4632 | 50 | ||||
| Tapezoid Tear (lbs) | D4533 | 85 | ||||
| Puncture (lbs) | D4833 | 115 | ||||
| Mullen Burst (psi)* | D3786 | 360 | ||||
| UV Stability (% at 500 hrs) | D4355 | 70** | ||||
| Permittivitiy (sec -1) | D4491 | 1.0 | ||||
| Water Flow Rate (gpm/ft.2) | D4491 | 75 | ||||
| Permeability (cm/sec) | D4491 | 0.25 | ||||
| A.O.S. (U.S. Sieve#) | D4751 | 80 | ||||
| A.O.S. (mm) | D4751 | .180 | ||||
| Weight (oz / yd2) | D5261 | 8T | ||||
| Thickness (mils) | D5199 | 85 | ||||
| * UltraTech does not advocate the use of mullen burst. ASTM Committee D-35 on geotextiles has not established mullen burst | ||||||
| as a geotextile test method. Mullen bust lacks correlation to geotextile applications and exhibits wide interlab variation. | ||||||
| ** Percent strength retained after 150 hours. | ||||||
| T Typical roll properties. | ||||||