DIRECTIONS
FOR USE: It is a violation of
Federal law to use of herbicides in any manner inconsistent with their labeling.
For any requirements specific to your State or Tribe, consult the agency
responsible for pesticide regulation.
KEEP
PEOPLE OFF TREATED AREAS UNTIL SPRAY SOLUTION HAS DRIED
When
to apply herbicides: Apply to vigorously growing plants. Apply to annual weeds any time after emergence.
For best results apply to perennial weeds after seed heads, flowers or
berries appear. On woody brush or
trees, apply after leaves have fully expanded.
Applications made at less than the recommended stage of growth may result
in reduced control. After mowing,
clipping or tilling, allow weeds to re-grow to the recommended growth stage
before spraying this product.
Rainfall
or watering within 6 hours after application can wash the product off plant
foliage which may require re-treatment. Delay
mowing, clipping, tilling, planting or sodding of treated areas for at least 7
days after application. This allows
time for this product to move within the plant for most effective results.
SINCE THIS PRODUCT DOES NOT WORK IN SOIL, RE-TREATMENTS WILL BE NECESSARY
TO CONTROL NEW WEEDS EMERGING FROM SEED.
One
application will control most weeds listed.
Symptoms on certain tough perennial weeds and woody brush and tree
species may be slow to develop. If
control is not achieved within 4 weeks, allow time for the sprayed weeds to
re-grow and make a repeat application. In
some cases, control of woody brush and trees treated in the fall may not be
fully apparent until the following season.
LAWN
RENOVATION: Best results are obtained when at least one mowing is
skipped prior to treatment. This
provides more leaf surface to intercept the spray.
For areas where renovation and re-seeding is desired, thorough spray
coverage of all existing vegetation is necessary. Delay planting or sodding of treated areas for at least 7
days after application.
ORNAMENTALS: Any ornamental species may be planted in treated areas 7
days or more after application. Apply
this product as recommended to control undesirable plants. To avoid injury on desirable plants, prevent spray or drift
contact with foliage, stems or green bard.
Do not spray into or over the top of growing ornamentals.
MIXING
AND SPRAYING: Do not apply this
product through any type of irrigation system.
HAND
HELD SPRAYERS: Add 3 to 6 fluid
ounces (6 to 12 tbsp.) of this product to 1 gallon of clean water.
Use the higher recommended rate for control of listed perennials and
brush. Use pump-up-type or
hand-trigger-type sprayers. USE OF
HOSE-END SPRAYERS OR SPRINKLER-TYPE DEVICES MAY RESULT IN POOR AND/OR ERRATIC
RESULTS.
Ensure
uniform and complete spray coverage, but do not spray plants to the point that
the spray solution runs off. Use a
coarse spray. Do not spray during
windy conditions, as spray drift may cause damage to any vegetation contacted.
CLEANING
EQUIPMENT: Triple-rinse spray
tank and flush all sprayer components with water to remove residues of this
product. After thorough cleaning,
equipment may be used to apply other products.
BACK
TO Concentrate