Use Morse Drum Cones and Clamp Collars to control dispensing of dry material from a drum! 
Replace your drum lid with a properly sized Morse Drum Cone and Clamp Collar. This allows you to control dispensing operation by turning your drum into a precise pouring instrument. Add a Morse Fork-Lift Karrier or Vertical-Lift Drum Pourer and you're ready to pour. Morse
Drum Cones are designed for controlled dispensing of dry powdered or granulated material and to reduce dust while discharging. Dispensing can be stopped almost instantly with a slide gate or iris valve. Attaching a Morse drum cone to your drum extends the reach of the pour by up to 15.5". This can be critical when you need to reach beyond obstructions at the receiving container.
Morse Drum Cones and Clamp Collars are available for standard 30 and 55-gallon steel drums, and standard fiber drums with inside diameters of 15.5", 17", 18.5", 20", 21.5", or 23". Specify 45° or 60° angle to the 6" discharge opening. Drum Cones and Clamp Collars can be made of carbon steel or electro-polished type 304 stainless steel. Carbon steel cones with 45° angle are seamless. Other cones, including those with 60° angle and all stainless steel cones, are welded. Each cone is supplied with a neoprene gasket on the flange that comes in contact with the drum rim. Carbon steel cone interior is treated with a rust inhibitor. Special coatings are available. Select Slide Gate (SG), Iris Valve (IV), Valve Flange (VF) without any valve, or just a 6"
opening depending on type of product dispensed. 
Optional Irus Valve
The Irus valve is designed with an aluminum body for controlling the flow of fine and coarse materials. The operator revolves the handle around the valve to open and close the flexible sleeve. A wide range of fine to coarse materials can be handled without clogging the iris valve.
Morse Clamp Collars secure the cone to your drum
Order a Clamp Collar to secure the cone in position onto the top of your drum. When ordering
cones or clamp collars, please specify the outside diameter of the top drum rim. Remove
the drum lid and take several measurements across the rim at various points and calculate
the average. Stainless Steel models are also available.
Click here for a copy of this spec sheet >>
| 
